French  German  English  Spanish
  French  German  English  Spanish


Fabrication Info and Tech Tips

Fabrication Instructions for Bail
(Not for use with StepLock)
  1. To form Bail Rod
    1. Screw Nuts (2) into handles (4)
    2. Bend rod to desired shape
      1. Check travel clearance with orthosis in flexion to allow complete �ROM�
  2. Final Assembly
    1. Remove Nuts
    2. Slip Fittings (3) into hollow handle (slotted end facing out)
    3. Lightly screw Nut into handle
    4. Slide rods through Nuts and into Fittings
    5. Tighten Nuts while holding rod in position
    6. Add stop set screw (5) to proximal section to prevent the cam from staying in the unlocked position


©Copyright 2020 by WSI
Created by WSI
This site is optimized for Netscape 4.0 and Internet Explorer 5.0 or higher. Please download an updated version